Tractor Talk Discussion Board |
Re: 966 question for Allen or Tractor Vet
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on November 16, 2006 at 17:18:50 from (75.19.123.100):
In Reply to: 966 question for Allen or Tractor Vet posted by BigMarv1085 on November 16, 2006 at 14:22:51:
Rather then welding them solid which i realy hate as SOME PEOPLE SHOULD NOT OWEN WELDERS , A&I makes a undersized arms for this perpose and i have had vary good luck with useing them . Remove the old one and replace with and undersized unit put the nut back on a tighten it back down and then there is a 1/2 inch clamp bolt that pulls it tighter . That oil leak can only be comming from the steering shaft seals and that is a 15 dollar repair , as they will leak like that sometimes and then stop lift the rubber dust flap up under the steering wheel and take a look . Now three time is twenty years i had to replace the BIG rubber seal that goes around the steering motor and this could also be the problem.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|