Tractor Talk Discussion Board |
Re: OT--Ford Triton V8 plug nightmare...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dhermesc on November 15, 2006 at 14:29:38 from (68.110.220.22):
In Reply to: OT--Ford Triton V8 plug nightmare... posted by Brian in NY on November 15, 2006 at 13:39:05:
Have the plugs ever been replaced? From the factory this rarely happens especially the 4.6L engine. When they blow with factory plugs it usually very early in the vehicle's life usually within the first 15,000 miles. Ford specifies 12-15 pounds of torque when tightening the the plug - doesn't take much more then that to strip the threads. Even though it was missing (usually coil on plug issue) when it went in to the shop I'm willing to bet cold hard cash one of the shop's monkeys with a socket wrench stripped it not knowing what the torque specs are. Now they want you to pay for their mistake. It's not "rare" for this to happen after the plugs have been replaced. Given the low tolerance of the torque spec and the aluminum threads even a person "following the book" while replacing them could have a plug blown - especially if they were difficult (galled plugs) to take out.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|