Tractor Talk Discussion Board |
here I go thinkin again!!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by phil lowe on November 13, 2006 at 18:52:28 from (142.68.170.78):
Hi guy's ,,with winter fast approaching I start thinking about how'm I gonna add extention on my backblade so I can get more of a cut when I got the blade angled.See it's only a 5 footer and when I angle it to throw the snow to one side I only get a three -4 foot cut ..thinking I could weld on extention ,,but then It would be hard to swivel it around ,,saw one on the Ad section that adjusts left n right ,,but to get something like that shipped to where I'm at ,,would not be worth it ... anyone build anything like this that wants to send a pic ,,just something to go by ..,, thanks Phil In Nova Scotia
Replies:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|