Tractor Talk Discussion Board |
Re: PTO extended through Hydraulic pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on November 12, 2006 at 05:09:15 from (148.78.243.24):
In Reply to: Re: PTO extended through Hydraulic pump posted by Garry Cottrell on November 12, 2006 at 04:46:35:
These things have been around since the stone age and you can buy 'em in any length ya want. I always use the 15" length; the 18" is really too long and anything else is too darned short to be of any use (for me anyway). Early PTOs had a hole drilled thru 'em and the machinery PTO shaft was held on with a bolt. Nowadays ya don't see that anymore, so you have to "chain" the pump forward to hold it and the extension in place. Then, your added implement will just snap on like usual. They are a very tight fit to your PTO, so clean up your shaft good. Might have to "tap" the extension on with a light hammer. You might see a tiny bit of "wobble" when you use one of these gizmos. Don't give it a thought. Darned thing only turns at 540 rpm anyway; not fast enough to even matter. Allan
Replies:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|