Tractor Talk Discussion Board |
Re: 4020 oil pump?? What to do????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jay pence on November 11, 2006 at 12:00:04 from (75.23.92.144):
In Reply to: Re: 4020 oil pump?? What to do???? posted by Bob on November 11, 2006 at 11:50:45:
this is of some help, I have already put the engine into the 4020, it fits tight but it does fit. I had the combine crankshaft pulley machined to be the same as the 4020 diesel. this was the easy part, I adjusted the fan blades and made a spacer so they don't hit. now my only problem is how to do this oil pump????. If i understand what your saying. The oil pump off the 4020 and the 6600 mount up the same. so install the 4020 pump??? What about the oil cooler. do I really need it? the combine engine uses a long tube that runs up the bottom side of the block that feeds the cooler and this is where ihave came to a halt at?? I am thankfull for any and all in put
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|