Tractor Talk Discussion Board |
Sandblasting as a first step ????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Question For You Guys on November 07, 2006 at 10:33:03 from (64.42.242.18):
I read here about "sandblasting" and I see photos in tractor magazines and have seen club members restorations where maybe the tin and some other parts are taken off and then the remainder is sandblasted before painting and reassembly. I realize that tape etc. is used to supposedly seal off seals, bearings, bushings, crevices, etc. but I've seen some of these restorations and I seem to find sand almost everywhere, most of it hidden of course but still there. In my opinion, it just is not the way to do it unless you are down to bare single and unattatched castings which I don't thik happens that often. What's your opinion on doing a restoration this way? I don't think I'd ever consider buying a restored tractor that was blasted in this way, you just cannot get all the sand off (or out) afterwards.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|