Tractor Talk Discussion Board |
by-gosh it worked
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by INCase on November 06, 2006 at 09:07:35 from (209.221.240.193):
I posted here about a week or so ago (can"t find it now) about a "temporary" fix to get a rear tractor tire to hold air long enough to get it home. The valve-stem to tube connection was bad and air came out almost as fast as it went in. Someone suggested spray foam insulation. While looking for the foam I noticed some marine "goop" adhesive. I put some "goop" around the valve stem/tube joint (the rim is completely gone there) and then sprayed foam around it the following day. Still leaked but not as bad but couldn"t get much air into it out in the field. Pulled it up to the guy"s garage and filled the tire with a compressor. "Over filled" it a bit and it looked like it was holding ok so we started to tow it the 5 miles to my place. 2 days later and its still full of air! thanks
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|