Tractor Talk Discussion Board |
Wimmens
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Aaron Ford on November 05, 2006 at 08:35:40 from (72.84.50.95):
Well yesterday I was minding my own business, rare for me, but ya know. I had heated the oil pump drive gear in the oven, frozen the shaft, and gotten completely ready for the installation. I was set up on the corner of the dining room table when I pulled the parts out of their respective places. About the second whack with the machinist hammer, she started yellin'. Turned out the top half wine glass that she had on the table decided to leave the bottom half and proceed about 6 inches into the air before coming splashing, crashing back down on the table. She was yelllin' for me to stop and now I have a half installed oil pump drive gear.... An' she don't understand what she did wrong....
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|