Tractor Talk Discussion Board |
Re: Before And After
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom R Ne on November 04, 2006 at 18:33:48 from (71.31.218.183):
In Reply to: Re: Before And After posted by Allan In NE on November 04, 2006 at 10:04:13:
If you section the bottom of the door on the same angle of the of the brace just slightly above the brace and set up an additional in-swinging hinge between the two sections, would the bottom two sections fold in as the door interferes with the brace as the door is swung out? As others have suggested a stack valve could be put together custom tailored to any configuration you need, also you could put a joystick operator on the valves for the lift and bucket cylinders. You could also use remote operator handles if you desired. A quick and dirty way would be just add a valve to run the grapple. You would need to buy a 20 GPM 4 way open center power beyond valve with a builtin relief valve. You could plumb this valve inline upstream of the present valve. You would need to set the relief valve on this unit to provide system relief and crank down the present relief valve on the old valve unit so that it does not operate.
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|