Tractor Talk Discussion Board |
Re: Kinda Bummed Out :(
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave from MN on November 03, 2006 at 12:14:37 from (67.133.91.28):
In Reply to: Kinda Bummed Out :( posted by Allan In NE on November 03, 2006 at 07:33:09:
Allan, I am no sure I under stand yer dilema, does that bottom 1/2 not fold up far enough? If so can you do some modification at the pivot points so it can fold a full 180 up against the window on the inside? Can you remove the hinge and ad 2 verticle slides on the bottem half up to the top half and just pull it up like when you open a house window. There has to be a way to avoid remiving the door. Anything else would just be uncivilized!!
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|