Tractor Talk Discussion Board |
Electronics 101 Question .....
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by MMB on October 25, 2006 at 15:35:07 from (64.42.242.10):
Here's a question for the electronic wizards here at the YT site. I remember ohms law but although it's involved here I think, my actual question relates to something else. Let's say that we are passing a DC current through a ceramic wire-wound resistor to ground. Let's suppose we have a circuit with 6 DC volts and 4 amps going into the resistor. The resistor is grounded. Which resistor would get hottest (as in temperature), a 3 ohm resistor or a 10 ohm resistor? So my question is, under identical conditions, would a low ohm resistor or a higher ohm resistor generate more heat? And if you can, maybe you could supply reason(s) for your answer. Thanks in advance.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|