Tractor Talk Discussion Board |
Re: Loader removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by glennster on October 23, 2006 at 07:23:30 from (68.78.69.159):
In Reply to: Loader removal posted by kestrel on October 23, 2006 at 06:42:49:
i made 2 braces that bolt to the rear of my loader on my m. i used 3X5 by 1/4 wall rectangular tubing with a piece of 3x5 welded to the bottom of each for feet. the feet sit about an inch off the ground when bolted up to the loader. . pull in the shed, bolt the brackets on, loosen the loader, raise the bucket just a little, back up a hair and lower the loader so the feet sit on the ground. then unhook the hydraulic hoses and back away. it looks like an upside down "T". takes about 1/2 hour to mount or dismount.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|