Tractor Talk Discussion Board |
Re: Help! rusted stuck axle pinion shaft on jd 70
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike M on October 10, 2006 at 05:54:41 from (24.140.28.219):
In Reply to: Help! rusted stuck axle pinion shaft on jd 70 posted by jubilee johnny on October 10, 2006 at 05:09:11:
You didn't say for sure if you got the wedge to move ? If so take it out drop the axle down and move the wheel where you need it and tighten it all back up and recheck it again a few times as it works in. Don't try to get it real tight all in one time. If you have time and want to loosen up the pinion slip the whole wheel off and soak it good in penetrant oil and use a VERY LARGE air impact and keep working it it should come loose. DO NOT HEAT as this will weaken the cast iron and make it crack !!!!
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|