Tractor Talk Discussion Board |
Re: tractor overheating
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom in TN on October 05, 2006 at 22:05:36 from (4.153.50.219):
In Reply to: tractor overheating posted by ron laws on October 05, 2006 at 21:37:30:
Ron, You're on the right track. Here's what I'd do if I were you: 1. Put the radiator back onto the tractor. 2. Reinstall the thermostat housing, but don't reinstall the thermostat. You'll have to get a new gasket for here eventually, but for now, just reuse the old one. 3. Open the drain plug on the bottom the radiator. 4. Using a water hose to refill the radiator, refill the radiator and start the tractor (leave the drain plug open on the radiator). 5. Run the tractor with the drain plug open and use the hose to constantly refill the radiator until the water coming out of the drain plug is pretty clean. 6. Stop the engine and go get some radiator flush at a parts store. 7. Follow the directions on using the flush. Don't reinstall the thermostat and don't refill the radiator with anti-freeze. 8. After completing the flush, refill the radiator with water and give it a try. If it's still overheating, remove the radiator and take to a radiator shop to have it "boiled out". Rodding the radiator actually involves removing the top and bottom of the radiator and running a rod through the tubes that go through the cooling fins. You probably don't need that, but the radiator shop will be able to tell when they clean and test the radiator. Put it all back together, buy a new thermostat, install it properly (it's easy to put it in backwards), refill the cooling system with water, and give it a try. If it stays cool, drain the water and refill the system with 50% water/antifreeze mixture. Good luck, Tom in TN
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|