Tractor Talk Discussion Board |
Re: Cutout on Case Vac
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by noncompos on October 04, 2006 at 22:15:15 from (71.34.66.23):
In Reply to: Cutout on Case Vac posted by Don E. Foster on October 04, 2006 at 20:15:12:
You mentioned polarising and cleaning/polishing the points; did you try to adjust the air gap? The cutouts I recall had a spring hooked over a tab on the back of the piece that held the top point, the piece that ran over the top of the little coil and closed downward, meeting the fixed bottom point to close the points. The spring tension could be adjusted by bending the tab the bottom end of the spring is hooked to,to give more tension to pull the points open, etc. The fixed (bottom) point was usually mounted on a long upside-down U-shaped little "stand", the two legs of the upside-down U generally bent inward about halfway up, like being a little knock-kneed. The bottom point could be raised by straightening the legs a bit, or lowered by bending the legs closer together. With us it was a hit or miss situation; if the cutout wasn"t working, fiddling with the point gap and spring pressure couldn"t make it any worse, and sometimes got it working again.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|