Tractor Talk Discussion Board |
Re: Compression ratio converted to PSI
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Maybe,,, on September 06, 2006 at 16:33:36 from (66.228.96.177):
In Reply to: Compression ratio converted to PSI posted by Brad in WI on September 06, 2006 at 02:14:17:
Just a guess,,,,, 100 psi 5 to 1 120 psi 6 to 1 140 psi 7 to 1 160 psi 8 to 1 180 psi 9 to 1 200 psi 10 to 1 220 psi 11 to 1 240 psi 12 to 1 260 psi 13 to 1 280 psi 14 to 1 300 psi 15 to 1 Thats just a guestimated pressure to compression ratio at cranking speed. There is no real way to make it exact, unelss you spec the engine out at 14.2 to 1 etc etc then run a compression test to get a relative psi number at cranking speed.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|