Tractor Talk Discussion Board |
Re: What implement should I use?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ultradog MN on September 06, 2006 at 10:08:29 from (71.220.90.162):
In Reply to: What implement should I use? posted by Double M on September 06, 2006 at 09:19:43:
Double, I'm not sure what kind of equipment you have. If you have a tractor with 3 point look around for an old 3 point cultivator. They made a couple of different types - stiff shank and spring shank but either would do the job. I've been clearing some land myself this summer - about an acre that is heavily overgrown - and after cutting it down with a brush saw I use the impliment below to kind of rake it up into windrows and tear up the roots some. Then I used the loader with manure forks to push, bunch and pile it up for burning. Good luck Jerry
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|