Tractor Talk Discussion Board |
Electrical power to pole shed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nick R (Wi) on September 06, 2006 at 05:56:44 from (209.103.193.10):
Just finished a machine shed and want to put power into the shed the proper way. What I now have is 100 amp 240 volt service disconnect box on a building 110 feet away. This box has a ground wire running from the common buss in the disconnect box to a ground rod. I want to install another curcuit breaker box in the shed with two 20 amp 120 volts circuits, one on each side of the common. Questions? Do I run another ground wire and rod at the shed or does it have to run back to the service disconnect box? What wire size should I use from box to box and does the steel roof and siding need any kind of grounding for protection. Thanks in advance for the input. Nick.
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|