Tractor Talk Discussion Board |
Re: Magnetos Coils
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on August 31, 2006 at 07:36:24 from (66.244.90.5):
In Reply to: Magnetos Coils posted by Doug in IL on August 31, 2006 at 07:12:05:
Doug, In addition to Bobs good answers, other things that can be hard on Mag coils are running plug gaps wayyyyyyy wider then specified and tripping a mag with no load like a spark plug or a plug wire to ground etc attached especially in mags that do NOT have an internal safety gap to short out the voltage spike. Its good to have any mag vent holes clean n open and humidity n dust n moisture and oldddddd age are just tough on 50 year old coils with the old technology insulations like Bob was talking about. John T
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|