Tractor Talk Discussion Board |
OT what paint will hold up on utility trailer
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DJL on August 26, 2006 at 22:29:30 from (70.105.70.21):
A little off-topic, but I need some advice. I've got a 5X8 utility trailer and a 18' tractor hauling trailer. Almost all highway usage, but 3 miles of gravel when I go back to mom and dad's farm. I'm tired of fighting the rock chips/rusting thats caused from the gravel hitting the tongue and front of fenders. I don't want to put "mega mud-flaps" on the pickup (wife has to drive it to work) What do you guys use that holds up? Three years ago, I completely stripped the 5X8 to bare metal, primed and used the home-installed herculiner, truck bed liner. I rolled it on. Held up okay everywhere except where the rocks chip. What do you guys use? I can't stand my trailers looking chipped up. Thanks DJL
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|