Tractor Talk Discussion Board |
Re: Farmall M Shimmy
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave 2N on August 21, 2006 at 06:59:38 from (74.32.146.159):
In Reply to: Farmall M Shimmy posted by Big un on August 20, 2006 at 16:32:32:
This is a common problem on the Farmalls. Do a post on the Farmall board for "Bob M" about this. We did a Super H this spring. A worn sector gear was a big problem so I put in a good used one. This helped a lot. We had already checked the wheel bearings and they were OK. We replaced the bolster bushing, upper bolster seal and bearings but I don't think these were that much of a problem either. We adjusted things, it was better, but we still found a lot of slop to be in the steering shaft universals and replaced them. Mu experience--hope this helps.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|