Tractor Talk Discussion Board |
Re: Who can remember?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by James2 on August 20, 2006 at 22:21:53 from (207.179.239.125):
In Reply to: Who can remember? posted by Oliver Power on August 20, 2006 at 06:45:56:
Our 1956 Ford 640 has the small shaft. The pulley drive we have, hooks directly to it. We also have the original Ford adapter which bolts on to the differential case. This adapter extends the shaft and resizes it so that it can be used on standard PTO equipment. I don't ever remember using the pulley drive, which was probably purchased when we bought a Ford 9N. The 640 replaced the 9N. We had a belted corn sheller but I can only remember it being used on the Farmall H, and that last happened in the real early 50's.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|