Tractor Talk Discussion Board |
Re: Tapered box steel for ROPS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by buickanddeere on August 15, 2006 at 19:37:48 from (216.183.138.78):
In Reply to: Re: Tapered box steel for ROPS posted by nballen on August 15, 2006 at 08:44:36:
The taper on the posts of a rops is designed in to allow it to spring gradual and flex some to absorb the crash energy. Otherwise the welds at the rops base, the clamps, the tractor axle housing of belhousing may snap. Very similar to how leaf springs are staggered in length. Initially a little pressure causes some deflection but as the weight/pressure on the springs increases, the spring rate increases.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|