Tractor Talk Discussion Board |
Re: Ford 961 Row Crop to All-Purpose height??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RWK in WI on August 14, 2006 at 06:45:18 from (69.95.237.116):
In Reply to: Ford 961 Row Crop to All-Purpose height?? posted by jjp on August 13, 2006 at 19:15:22:
I saw a "Mutt" tractor made from a 771 engine and front end ( the SOS transmission had gone bad ) and a 661 rear half ( early diesel that had blown holes in the block ) They had a belly mower on it and loved it for mowing an old cemetery. They had 10 inch front wheels in place of the 16s but the front still stuck up high. So, yes, it can be done but you have to decide if it is worthwhile.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|