Tractor Talk Discussion Board |
Re: Cracked Block
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Johnski on July 22, 2006 at 18:43:04 from (24.62.133.203):
In Reply to: Cracked Block posted by Matt Kane on July 22, 2006 at 08:59:10:
If the crack hasn"t spread past the ends of the weld and it really is a pinhole or two the you can repair it with solder. Clean up the area with a wire wheel, use a rosebud tip to warm it up, then flux and lay some solder over the spot. Auto body lead works best but 50/50 plumbing solder will work too. I had an 8 inch crack in the side of a 335 Cummins that was done like this and lasted the 10 years we had it. HTH Jf P.S. I showed the crack to the new owner and he still bought the truck.
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|