Tractor Talk Discussion Board |
Haying Pic #2
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Matt from CT on July 08, 2006 at 18:30:09 from (24.177.7.45):
In Reply to: Haying in Connecticut posted by Matt from CT on July 08, 2006 at 18:25:14:
And on this side, we're tedding. IIRC the tractor was a 4020...but I didn't write it down. I had to run down to Home Depot late in the afternoon when my local hardware stores didn't have the right size part I needed for a project, and drove back by here, alas without a camera. The field in the first pic had already been baled and cleaned up. An older gentleman was running a small square baler dropping them on the ground. An older lady was running the JD in this pic, now pulling a side-delivery rake to make the windrows (the field hadn't been windrowed in the AM). Meanwhile, the field in this pic by 5pm had been windrowed, and half of it was already in round bales (guessing 4 x 4). Baler being towed by a Ford.
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|