Tractor Talk Discussion Board |
Re: Unscheduled trailer brake check
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by richard in nz on June 30, 2006 at 15:28:05 from (222.152.218.122):
In Reply to: Re: Unscheduled trailer brake check posted by souNdguy on June 26, 2006 at 06:11:55:
In England chains are not permitted, a trailer with a gross wieght of more than 750kg capable of travelling at more than 40kmh must have a device that will cause the brakes to be applied if the trailer comes disconnected at the drawbar, this is usually a thin wire about 1/8" that will yank the trailer parking brake on then break allowing the trailer to come to a standstill rather than having a trailer flailing about on the end of a chain which can cause the towing vechcle to go out of control. The safty brake wire was attached to the drawbar frame, I lost the drawbar frame so the brakes were never applied! The trailer ended up on the hard shoulder of the M5 Motorway in Worcestershire still coupled to the hitch! I was wery lucky that day that the trailer went up the nearside, Britins roads are very overcrowded and there were 3 lanes of traffic all doing 70mph and then some. I live in New Zealand now, very much less busy!
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|