Tractor Talk Discussion Board |
Re: Grease zirk problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hurst on May 24, 2006 at 18:22:36 from (66.129.5.5):
In Reply to: Grease zirk problem posted by old on May 24, 2006 at 15:31:39:
The only thing I have ever done that seems to work on about 95% of the tips I have (if it doesnt work, they are replaced as there is more than grease clogging them) is to put them in the vice, and light up your blow torch (propane torch) and heat her up. Be careful, as they will pop and can shoot some nasty spirts of hot flaming grease out at you. Stand back and don't do it near a baler or dry grass... Afterwards, put a little penitrating oil in it to loosen up anything left and you should be good to go. Some do just seem to clog up for no reason at all though??? go firgure Good luck Hurst
Replies:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|