Tractor Talk Discussion Board |
Re: 9n 3 point
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mn.Chuck on May 10, 2006 at 16:56:13 from (67.72.98.82):
In Reply to: 9n 3 point posted by stan frank on May 10, 2006 at 12:11:02:
Control Valve is stuck. If you take a round side cover off(drain some oil down or tilt tractor to the opposite side of cover removed)you will see the two arms coming down from the top cover. They cradle the valve that is not moving. A clip pin on ea arm holds them to the moveable valve. Remove them and try to gently tap the valve or pull out and look for a small piece of brass or sliver that is causing it to stick-loosen it up-best w/o removing it completely and it should work. Caution if something is on 3 pt it may come down with a bang. Remove anything that is on the 3 pt. Chuck
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|