Tractor Talk Discussion Board |
Re: question ... removing tie rod end ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JWC in MS on April 19, 2006 at 15:23:26 from (199.133.80.226):
In Reply to: question ... removing tie rod end ??? posted by MMB on April 19, 2006 at 14:21:54:
There are tierod end removal tools. I bought one 30 years ago and still cherish it. The tool has a solid metal handle with a wedge shaped fork on one end. The fork goes between the ball portion of the tierod end and the steering arm. It is very handy in conditions where there is no room to swing a hammer. It also saves you from putting a lot of extra torque on the steering arm. You should be able to find one at almost any auto parts store. In todays world of cheap imported tools it will probably cost less than $15 to $20. If you break something else beating with a hammer it will cost more than using the right tool to begin with. Good Luck!
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|