Tractor Talk Discussion Board |
Re: vented gas cap for 800 Ford
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scott PA on April 11, 2006 at 18:14:03 from (152.163.100.74):
In Reply to: vented gas cap for 800 Ford posted by abane on April 11, 2006 at 10:51:54:
Ford came out with a free safety gas cap exchange offer in 1986 to make sure all the 1939-1982 Ford gas tractors get the new style large vented cap with spill prevention in a rollover, New Holland now continues to offer it also, take your current cap, the hours from the meter, the model# and the hand stamped serial number with a diamond at each end located at the top left front corner of the transmission housing straight below the air cleaner to your local New Holland dealer and they will give you the free safety cap with a long plastic neck and large vent holes in the top, if they are a new dealer and do not know anything about it tell them to refer to service bulletin 1993/10-T2 to get reimbursed from New Holland, keep the gas level below the bottom of the plastic neck of the new cap..
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|