Tractor Talk Discussion Board |
Re: There, That's Done
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on March 06, 2006 at 04:09:59 from (148.78.243.25):
In Reply to: There, That's Done posted by Allan In NE on March 05, 2006 at 14:17:13:
Hi Billy, The box is made up of a series of "sissoring" crossbeams, which actually can be dumped either out the left side or to the right. You'll notice a couple of hooks to either side of the wheel openings. These were used via cables back in the days before the invent of hydraulics. When the truck dumps rearward, the lower fore/aft stringers in addition to the crossbeams are lifted as a unit. When it tilts sideways, two different cylinders are mounted in such a way that only those sissoring crossbeams are activated. Finally, two more cylinders are mounted horizontialy and at each end of the left sideboard and run that opener/closer linkage. It's dark outside or I would send you a picture. Instead, I scanned this one for ya out of the manual. After all the mending that needs to be done, I'll paint the sides and oil the floor with used engine oil. Allan
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|