Tractor Talk Discussion Board |
OT 350 engine help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike in Ind. on February 26, 2006 at 17:47:30 from (71.115.90.63):
Tore down my friends 350 engine in his suburban this weekend to change the head gaskets. Got it all back together and now doesn"t want to run right. Runs for a few seconds and then backfires through the carb and dies. I marked the distributer before I took it out and the crank was not moved while it was apart and it went back in and lined up where it should so I don"t see how the timing can be the problem. When I adjusted the pushrods the haynes manual said to tighten the the rocker arm nut untill all the play is gone and then tighten them another 3/4 turn. I have been told by many people that is is better to have them a hair loose than too tight so I only gave them another half turn instead. Near as I can figure I got one of the intake valves too tight. All opinions apprecaited. Thanks. Mike.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|