|
Tractor Talk Discussion Board |
A Lot Of Steel In Those Things!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by in-too-deep on February 23, 2006 at 13:37:30 from (152.163.100.74):
I'm in the process of cutting up two 100 gal. water heaters. They are approx. 30 yrs. old and have to be cut up to be removed from a basement. I am amazed at the amount of steel those things use. The tank sides are 3/16" and the top and bottom are 1/4" at least. Plus, 7 flue pipes going up through the middle made of 3/16" wall. The new ones weighed about 700 lbs. a piece, so I figure the old 'uns are that atleast. When it's all said and done I'll have about 1500 lbs. of prepared steel to take in. Hello scrap man, I'll take that in 50's. Hello boss, here's the money for those heaters :( Boy, you should've seen the way we got the new ones down there. Took out the stairs and lowered them straight down with a chain hoist. It was quite an experience being under 700 lbs. of dangling water heater. After all that I'm the guy that gets to spend some quality time with a torch on the old ones.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
