Tractor Talk Discussion Board |
timing injection pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randall Baggett on February 19, 2006 at 16:37:40 from (67.136.141.5):
I have a Massey Fergusson 500 crawler with a V-8 perkins engine. I need to time the injection pump but someone has changed the crankshaft pulley and replaced it with one that has timing marks. The original did not have timing marks but had a pen that screwed out from the crankcase and entered into a hole in the back of the crankcase pulley when the crankshaft was in the correct location to time the pump. Any body got any suggestions on how I could time it without the correct crankshaft pulley. The manual says it can be done by observing the position of number 1 cylinder valves.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|