Tractor Talk Discussion Board |
Re: welding cast iron info
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by george md on February 08, 2006 at 14:04:50 from (12.191.226.99):
In Reply to: welding cast iron info posted by INcase on February 08, 2006 at 07:16:51:
Incase, If you would like to read the how and why of cast iron welding that is written by a fellow who does much cast repair rather than by someone who is in the biz of selling welding supplies, you should read the link below .It is written by Gary Reed who not only welds cast (mostly oxy/ acetylene) and who designed and patented the lock-n-stitch repair tools. His brother Guy Reed showed up here on the board a year or better ago with some pictures of manifold repair very similiar to what I do . http://www.locknstitch.com/CastIronWelding.htm Below are url's to some cast repair that I did.
http://www.georgemillermachine.com http://www.imageevent.com/gmachine george
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|