Tractor Talk Discussion Board |
Re: Allan in NE
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on April 04, 2006 at 05:18:47 from (148.78.243.26):
In Reply to: Re: Allan in NE posted by hayray on April 04, 2006 at 04:25:45:
Hi Ray, Appears pretty "flip-floopy" don't it? :>) Normally, and if I could have been lucky enough to have gotten this patch fall-plowed, I wouldn't even be thinking about it; I'd just run the packer over it and be done with it. Without publicly going into details tho, there were some issues with the purchase agreement and I wasn't able to plow this field until this spring because the prior operator's hay stacks didn't get removed until just a few weeks ago. So, here I set with a "slabby" mess and it looks like the disc is going to be the only option if I wanna get it cut up and worked down this summer. I've plowed a lot of sod, but this root infested, cattle tromped pasture is the worst I've ever ran into. So, I'm gonna give your method a trial and hope beyond hope that I luck out and get a rain on it to help melt it down before September. Allan
Replies:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|