Tractor Talk Discussion Board |
Re: 2 or four inch pipes?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve Crum on March 30, 2006 at 21:29:26 from (4.156.231.195):
In Reply to: 2 or four inch pipes? posted by Tim Shultz on March 30, 2006 at 07:44:33:
I've built all kinds of systems for all kinds of engines and build what the customer requires. The customers that listen to me are usually the most satisfied. 2 1/2" duals are more than enough for even a 500 ci Cadillac engine. cross over the 2 1/2" diameter (2 3/8"id) threshhold and unless you have a 6-71 Detroit blower on it you've screwed your flow velocity and inturn your volumetric efficency, read this as a major loss of horsepower and torque. Flowmaster mufflers are nice if your into paying twice as much for a trademark with no appreciable improvement in quality, Flotec's are my choice if I don't build my own and if I use cats they are the Magnaflow stainless jobs, (EPA approved). Cats then mufflers and then the straightest possable shot out the back
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|