Tractor Talk Discussion Board |
Re: Lo-Boy 185 hydraulics question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by K-Mo on March 28, 2006 at 06:43:42 from (65.169.189.2):
In Reply to: Lo-Boy 185 hydraulics question posted by MeAnthony on March 27, 2006 at 15:45:07:
You have enough PSI but not enough pump capacity (Gallons Per Minute, GPM). Think about how fast your 3-Point and mower raise when one cylinder is supplied. On a loader you will have two lift cylinders and at times two more bucket cylinders to supply. I have an I-240 with a loader that I need to install a separate pump on for the loader. Now, when using the tractor pump, beside being very slow, the loader will drift down if I try to raise and tilt at the same time.
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|