Tractor Talk Discussion Board |
Re: lift-all
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by john d on January 15, 2006 at 15:06:03 from (69.128.201.212):
In Reply to: lift-all posted by jack w on January 14, 2006 at 14:57:10:
As the previous poster said, disconnect all the plumbing, control arm, and the drive coupling. There are numerous ways to lower it - threaded rods in place of two bolts, handle WITH a key welded to it through the bottom hole that goes through the casting, or simply strong arms. It will likely be heavier than you expect it to be. KEEP YOUR HANDS, FEET, AND HEAD OUT OF THE WAY WHEN IT COMES DOWN!
Replies:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|