Tractor Talk Discussion Board |
Re: m444 skidloader carb questions
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom H on January 14, 2006 at 18:55:10 from (205.188.117.14):
In Reply to: m444 skidloader carb questions posted by andrew stegman on December 26, 2005 at 16:12:06:
Hi, I also have a M 444 and went to my Bobcat dealer and picked up the service manual for nearly the same reason. Anyway it says to adjust the float; with the carburator casting inverted and the float resting lightly against the needle in its seat, there should be 0.3125 inch (1/4 inch woth styrofoam float) clearance between the bowl cover gasket and the free end of the float (side opposite the needle seat. good luck, Tom ps. you can email me with any other questions. I also have an orifinal M444 operator manual and parts book. the part numbers do not match the current Bobcat numbers but the diagrams are great.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|