Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: hauling combine ,height ,suggestions


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by the tractor vet on December 24, 2005 at 06:49:18 from (4.124.73.130):

In Reply to: Re: hauling combine ,height ,suggestions posted by RustyFarmall on December 24, 2005 at 06:27:53:

The cost of hauling and large combine can get expencive by the time you start buying permits for a one time move and all depends on where you are hauling from and to . Use to be , now like i said use to be that in Ind. you could haul up to 14 foot wide in farm equipment but then then learned that they could make more MONEY from selling permits and fines so now ya have to have a permit . In the Buckeye i can get a yearly premit for Ag. or constructoin up to 14 foot with escort as long as i don't go overweight for about 20 bucks or over 14 foot high . Now i have moved small combines on a one ton but like you said the wind will killya you think that you are dragen fifty ton behind ya. I hauled one littel gleaner E III from Plymouth Ind. back home and of all nite the wind was comming out of the east at around 15 to 20 MPH From Plymouth to Ft. Wayne on US 30 i ate 27 gal of gas and Ft. Wayen to Beaver Dam it took 35.6 the tanks only held 36and a half from there to Dalton it took another 32 gal and had to stop in Canton and put another 26 in it for the last thirty miles. That load pulledharder then when i was real stupid and brought back a 1066 and and 806 both with weights and duals way tomuch for a one ton and a tandem dual traiel.


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy