Tractor Talk Discussion Board |
Re: Sears Custom 7 Engine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by lucasss on December 18, 2005 at 18:15:58 from (209.240.205.61):
In Reply to: Sears Custom 7 Engine posted by Mmatto99 on December 17, 2005 at 19:40:58:
i dont know of another engine with the mountings for the clutch pedal . allthough a custom 6 or 8 engine will fit.those engines have a cast iron bore and can be rebuilt.the 10 and 12 hp hh100 and hh120 sears engines had the same clutch pedal mountings too .i rebuilt my custom 7 in 82 and used it 20 years more.i bored it.it still runs great but i got a woods zero turn i use mostly now. there is a tecumseh rep at the perr.com forum named tecumpman,you could direct your question there to him,he may know something else. lucas
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|