Tractor Talk Discussion Board |
Re: Ford F150 buring oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bus Driver on December 17, 2005 at 10:02:36 from (66.226.35.171):
In Reply to: Ford F150 buring oil posted by Hurst on December 17, 2005 at 09:21:01:
Two inexpensive things to try are to install new PCV valve and to add SeaFoam to the crankcase. My oldest car started leaking oil and the oil seal leakstop made it worse. Discovered that my PCV valve was clogged. Caused pressure to build inside the engine. A new PCV valve for less than $3.00 stopped the leak entirely. SeaFoam is an expensive product. I have little experience with it, but have heard lots of enthusiastic support and no derogatory comments. The oil rings for those cylinders might be stuck and the SeaFoam is supposed to help that.
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|