Tractor Talk Discussion Board |
Re: Herniated disc., Chuck t . Question???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jdemaris on December 15, 2005 at 18:51:03 from (66.218.13.238):
In Reply to: Re: Herniated disc., Chuck t . Question??? posted by VaTom on December 15, 2005 at 09:36:13:
I agree with your approach. If I were to take it easy, I'd be in much worse shape than I am. I was cutting firewood and building a barn while wearing a neckbrace after my last operation. But . . . as far as not doing dumb things . . . ?? You must be better at it then I am. When I've been doing my exercises on a regular basis, and get feeling pretty good -I start lifting heavy stuff again. Then I pay for it. If I lift something over a 100 lbs. I feel fine at first, i.e. no pain at all. Takes a day for the damage to kick in, to make me feel miserable. Then I curse myself for being such d*mn fool, I start doing the exercises like crazy, and wait to get better again. The funny thing with bad discs - at least mine - is you usually don't get immediate cause and effect. Sometimes I wish it did - then maybe I'd be more careful.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|