Tractor Talk Discussion Board |
Re: OT-Attn Jeep/Chry Techs need help w/wiper moto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pete7 on December 14, 2005 at 16:16:09 from (64.12.117.7):
In Reply to: OT-Attn Jeep/Chry Techs need help w/wiper motor posted by Redd on December 13, 2005 at 15:49:58:
Redd. I just went thru the same thing with the rear wiper on a Cherokee (not a Grand Cherokee however and while the wiper looks similiar to what's in a Grand it is not a perfect swap) Anyhow, I tried two motors from a junk yard and neither worked. They just make a clicking sound. Ended up buying a rebuilt for about $100 and the instructions on it said to be real careful not to reverse the polarity or you would jam up the gearing. I did try to test the junkyard ones so perhaps I jamed them up. So I didn't try to test the rebuilt one before I installed it and instead bolted it in place and then hooked it up with the original electrical connector. Everthing worked out fine. Pete
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|