Tractor Talk Discussion Board |
Question for you Ford experts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Steve Crum on December 07, 2005 at 07:14:03 from (4.156.231.170):
Being primarily a GM man, I'm a bit at a loss. I have an 89' F-150 ext cab pickup with the 5.0 FI engine, 5 speed stick and it's 4 wheel drive. In the past few weeks it has developed a a miss or "stumble" at about 50 mph. It's lacking for the power it previously had and fuel mileage is gradually going south. It was tuned up this past summer with ALL new ignition and the distributor bushings were not worn, also it's been completely serviced including a new air filter. This just started happening in the past few weeks and has had 3 tanks of gas thru it since this has been going on. Any peculiarities to this engine that happen that might cause this? On a GM I could probably track the problem down in short order. I'm just not familiar enough with Fords. I must say, I've had this truck for 2 1/2 years and it has changed a lot of the paradigms I had about Ford trucks.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|