Tractor Talk Discussion Board |
Re: who sells v-8 chevy adapters for a farmall h
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on November 19, 2005 at 07:39:08 from (66.228.96.169):
In Reply to: who sells v-8 chevy adapters for a farmall h posted by martind on November 18, 2005 at 05:41:02:
Good Luck trying to put the chevy in the H bellhousing, The H is too narrow to fit it all in. You would have to move the 350 forward to make it all clear to have room for the starter. In the H"s, the best method I see, is to use a 4 speed cast bellhousing and bolt it directly to the H engine plate, use the input shaft out of the 4 speed, that has the shaft bearing inthe bellhousing, then adapt the Chevy shaft, to the H shaft. The you can use the chevy flywheel, clutch, well, all the chevy components and not have to do much customizing,, the front mounts will be a pain, the H rails are too narrow, but, you could get a set of frame rails from a 460, that would open things up quite a bit, then you can build stands to mount the front of the engine into the frame rails. its simple to bolt the bellhousing to the H engine plate, and hook up the clutch and input shaft, its fromthe bellhousing forward is where you run into the problems on space for accessories. Hope this helps, ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|