Tractor Talk Discussion Board |
Re: Right size of Mower for tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dick L on October 18, 2005 at 17:39:45 from (172.171.178.33):
In Reply to: Right size of Mower for tractor posted by Tramway Guy on October 18, 2005 at 07:03:48:
I have had a 5 foot finish mower and a 5 foot brush hog that I have used with my Symplicity 9523 which is the same as the Allis 5020. Both work just fine with it. They cover the width of the tractor plus. I have a loader with a 4 foot bucket. It is just slightly wider than the front tires but the rear turf tires are a bit wider. I chopped four acres with the brush hog two feet higher than the tractor in second gear this summer. Only problem was the screen in front of the radiator plugged and caused it to over heat about three times. I bought it new in 1980 and have used it rough all these years. For over ten years I mowed over ten acres of grass. Still starts and runs like a champ.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|