Tractor Talk Discussion Board |
Re: gas to alcohal conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RN on October 12, 2005 at 16:18:27 from (24.183.39.44):
In Reply to: gas to alcohal conversion posted by chris sweetland on October 12, 2005 at 15:13:53:
Alcohal? On air cooled engine without a external oil cooler or filter may have problem preheating Ethanol. Try 2 fuel tanks- 1 gas, 1 Ethanol. have a steel fuel line for Ethanol close to head for a bit of preheat before going to carb. may try a Ubend toward front where warmed air can blow across line. Main jet on carb - enlarge about 10% and adjust from there. If trying Methanol- you will have graeter solvent affect on gaskets. Side valve engines for high compression- popup piston slanted toward valves- check old Ford hotrod ideas or Harley KHK pattern piston design. Watch out for gasket leaks- replace rubber with metal or teflon gasket material. check carb float for resistance. RN.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|